Sherwood RD-5503 Betriebsanleitung PDF herunterladen (Seite 16)

ENGLISH

• While playing digital signals from Dolby Digital program source or listening in Dolby Pro Logic II Music mode, you can

adjust their parameters for optimum surround effect.

• Then "NIGHT : ~ " (or "PANO : ~ ") is displayed for several

seconds.

• If the parameter mode disappears, press this button again.

When adjusting the sound parameters

1. Press the SOUND PARAMETER button.

2. Press the CURSOR UP(▲)/DOWN(▼) buttons to

select the desired parameter.

• Each time these buttons are pressed, the parameter mode

changes as follows:

→ "NIGHT" ↔ "PANO" ↔ "C.WIDTH" ↔ "DIMEN" ←

(Night mode) (Panorama mode) (Center width control) (Dimension control)

• "NIGHT" can be selected only while playing digital signals

from Dolby Digital source.

• "PANO", "C.WIDTH" and "DIMEN" can be selected only

while listening in Dolby Pro Logic II Music mode.

󳂮When selecting the "NIGHT (Night mode)"

This function compresses the dynamic range of previously

specified parts of Dolby Digital sound track (with extremely

high volume) to minimize the difference in volume between

the specified and non-specified parts. This makes it easy to

hear all of the sound track when watching movies at night

at low levels. The night mode can be set in 11 steps from

0.0 to 1.0 (default value : 0.0).

󳂮

Note : In some Dolby Digital softwares, the night mode

may not be valid.

󳂮

When selecting the "PANO (Panorama)" mode

This mode extends the front stereo image to include the

surround speakers for an exciting "wraparound" effect with

side wall imaging.

Select "OFF" or "ON"(default value: OFF).

󳂮When selecting the "C. WIDTH (Center width)"

control

This adjusts the center image so it may be heard only from

the center speaker, only from the left/right speakers as a

phantom image, or from all three front speakers to varying

degrees.

The control can be set in 8 steps from 0 to 7(default value :

3).

󳂮

When selecting the "DIMEN (Dimension)" control

This gradually adjusts the soundfield either towards the

front or towards the rear. The control can be set in 7 steps

from -3 to +3 (default value : 0).

3. Press the CURSOR LEFT(◀)/ RIGHT(▶) buttons to

adjust the selected parameter as desired.

4. Repeat the above steps 2 and 3 to adjust other parameters.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 41 42

Kommentare zu diesen Handbüchern

Keine Kommentare

Sherwood RD-5503 Betriebsanleitung Seite 16

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Audio-Tuner Sherwood RD-5503