ENGLISH
11
“T-DIR” is displayed and the sound that bypasses
the tone circuitry will be heard.
To cancel the tone direct function, press this button
again to display “D-OFF”.
To listen to a program source without the tone effect.
10
Each time this button is pressed, the corresponding
tone mode is selected and shown for 5 seconds as
follows:
BAS(s) TRE(ble)
Note:
When the tone direct function is activated, the tone
mode cannot be entered and “T-DIR” is displayed.
Enter the tone mode.
8
If the tone display disappears, start from the step 8
again.
Notes:
Extreme settings at high volume may damage your
speakers.
In general, the bass and treble levels are adjusted
to 0.
At the desired tone mode, adjust the tone
as desired.
9
Adjusting the tone(bass and treble)
“BAL” is displayed for 5 seconds.
Enter the balance mode.
11
If the balance display disappears, start from the
step 11 again.
When the BALANCE ∧/∨ buttons on the remote
control are pressed, it enters the balance mode
automatically without pressing the BALANCE
button on the front panel.
Note:
In general, the balance level is set to the center
position(red dot).
Adjust the sound volume balance between
the left and right speakers.
12
Adjusting the sound volume balance
Kommentare zu diesen Handbüchern