Sherwood Newcastle R-972 Bedienungsanleitung PDF herunterladen (Seite 65)

• You can adjust the crossover frequency within the range of

50 ~ 200 Hz.

• Select "FULL" when the selected speaker can fully

reproduce the low frequencies below 50 Hz.

When selecting the Crossover Frequency

■Note :

• You cannot select the subwoofer and the speakers set to

"No".

• Only when the Trinnov Position is set to "None", you can set the Crossover Frequency manually. (For details, refer to "When

selecting the Trinnov Position" on page 72.)

• Set the crossover frequency according to the frequency characteristics of the speakers connected.

(For details on the frequency characteristics, refer to the operating instructions of the speakers.)

• If the frequency range of your speaker is 100 Hz ~ 20 kHz, the crossover frequency should be set to 100 Hz (or slightly higher).

• The low frequencies below the crossover frequency are to output from subwoofer or the speakers which are set to "Full" (when

not using a subwoofer).

1. Press the CURSOR UP(▲)/DOWN(▼) buttons to select the Crossover Frequency, then press the ENTER

button.

2. Press the CURSOR UP(▲)/DOWN(▼) buttons to select the desired speaker.

3. Press the CURSOR LEFT(◀)/RIGHT(▶) buttons to set the crossover frequency as desired.

4. Repeat the above steps 2 and 3 until the crossover frequencies are all set as desired.

ENGLISH

R-972(A)_ENG_090225:R-972(A) 2009-04-15 오 9:01 페이지 65

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 91 92

Keine Kommentare

Sherwood Newcastle R-972 Bedienungsanleitung Seite 65