Sherwood RD-6505 Betriebsanleitung PDF herunterladen (Seite 21)

ENGLISH

Adjusting the current channel level

• Each time these buttons are pressed, the corresponding

channel is selected as follows:

→ REF 1, 2 (or CAL) ↔ FL ↔ C ↔ FR ←

→ <DTS or DD> ↔ SW ↔ SL ↔ SR ←

< >: Only when the digital signals from Dolby Digital or DTS

program sources are input, these levels can be displayed.

• Depending on the speaker settings ("N (No)") and

surround mode, etc., some channels cannot be

selected.

• When the SPEAKER button is set to off, only the Front

Left and Front Right channels can be selected.

• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources or

to suit your tastes.

• You can adjust the current channel levels as desired. These adjusted levels are just memorized into user’s memory

("CAL"), not into preset memory("REF 1", "REF 2").

• The LFE level can be adjusted within the range of -10 ~

0 dB and other channel levels within the range of -15 ~

+15 dB.

• In general, we recommend the LFE level to be

adjusted to 0 dB.(However, the recommended LFE

level for some early DTS software is -10 dB.) If the

recommended levels seem too high, lower the setting

as necessary.

CH.LEVEL

PRESET

• Then the memory mode ("CAL", etc.) is displayed for

several seconds.

• When the memory mode or channel level disappears,

press this button again.

TUNE

1. Press the CHANNEL LEVEL button.

2. Select the desired channel.

3. Adjust the level of the selected channel as

desired.

4. Repeat the above steps 2 and 3 to adjust each

channel level.

RD-6505(A)_100223_RD-5503(g) 2010-05-11 오전 9:52 페이지 21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 124 125

Keine Kommentare

Sherwood RD-6505 Betriebsanleitung Seite 21